Osteoporosis and DEXA Results: T-Scores, Osteopenia and Fracture Risk
Learn what a bone density report measures and what information helps your clinician estimate fracture risk.
Report glossary
How to read the main DXA report terms
The classification table below applies to valid diagnostic sites in the adult populations specified by ISCD. A clinician checks whether those criteria fit the person being assessed.
Terms to bring to a result review
| Term | What it tells you | Question to ask |
|---|---|---|
| Bone mineral density (BMD) | The measured density at a named site | Which site was usable and why? |
| T-score | Comparison with a young adult reference value | Does the T-score classification apply to me? |
| Z-score | Comparison with an age-appropriate reference group | Is the result below the expected range for my age? |
| FRAX estimate | Ten-year fracture probabilities from clinical factors, with or without femoral neck BMD | Which version and inputs were used? |
| Least significant change | The size of a BMD change needed to exceed expected measurement variation at that service | Are these two scans directly comparable? |
T-score categories in the standard adult classification
| T-score | Description |
|---|---|
| −1.0 or higher | Bone density in the normal category |
| Below −1.0 and above −2.5 | Low bone mass, also called osteopenia |
| −2.5 or lower | Bone density in the osteoporosis range |
What does a DXA scan measure?
DXA and DEXA refer to dual-energy X-ray absorptiometry. A bone density scan uses low-dose X-rays, usually at the hip and lower spine, to estimate bone mineral density. A forearm site is used in selected situations. The result describes the sites scanned.
A clinician may request the test after a fracture from a minor fall, when age or health history raises risk, or when the result will guide a treatment decision. Some medicines, including long-term oral glucocorticoids, affect the risk assessment.
How should you prepare for the appointment?
Follow the instructions from the scan service. Loose clothes without metal fastenings can make positioning easier. Tell the service about possible pregnancy, recent contrast imaging, implants or surgery in the area and difficulty lying flat. Take your previous report if the team has asked to compare results.
The scan usually takes place on an open table. The operator positions your hip or spine, and asks you to lie still while the arm moves above you. Ask whether the service will send the result to the referring clinician and when to arrange a review.
Who uses a T-score or Z-score?
The International Society for Clinical Densitometry uses the standard T-score categories for diagnosis in postmenopausal women and men aged 50 or older at appropriate sites. A Z-score is usually preferred for premenopausal women and men under 50. A Z-score of −2.0 or lower is described as below the expected range for age under ISCD reporting guidance.
A low result in a younger adult can prompt assessment for an underlying cause. Bone density alone does not establish osteoporosis in men under 50. Tell the clinician about your fracture history because clinical context can change decisions at any age.
Why do hip and spine results sometimes differ?
Bone density varies by site. Positioning, arthritis, hardware and other changes can also affect measurements or make one site unsuitable. Ask which measurements the clinician relies on and whether the report mentions an excluded vertebra or other limitation.
For repeat scans, the staff can check whether the equipment and measurements allow a valid comparison. A small numerical change may be within expected measurement variation. Ask whether the difference exceeds the scan centre’s least significant change before interpreting it as improvement or decline.
What does osteopenia mean for fracture risk?
Osteopenia is a bone density category. Fracture risk depends on other information too, including age, previous fracture, family history, smoking and relevant conditions or medicines. A fracture from a fall from standing height or less should be mentioned even if the scan is above the osteoporosis range.
FRAX estimates ten-year risk of a hip fracture and a major osteoporotic fracture using a country-specific model. A clinician can explain which risk factors were entered, whether femoral neck BMD was included and how the estimate fits local treatment guidance. The estimate does not capture every circumstance, and a recent fracture or frequent falls can change how the clinician interprets it.
What should you discuss after the result?
Ask if the plan includes blood tests for possible causes, a review of falls and medicines, or changes to nutrition and physical activity. Tell the clinician about recent height loss, new back pain or a prior fracture. These details may change whether spinal imaging or another assessment is needed.
If an osteoporosis medicine is discussed, ask about its expected benefit, how to take it and what follow-up is planned. The weekly alendronate guide describes formulation-specific administration questions. The balance exercises guide can help you prepare questions about falls prevention and safe progression.
Export product support
Need product, pack, and documentation details?
Global Medicines Export can support international B2B enquiries for product availability, strengths, pack information, quotation coordination, and shipment documentation review.
Common questions
Is DEXA the same as an ordinary X-ray?
Both use X-rays, but DXA is designed to quantify bone mineral density. Other imaging may be needed to assess a possible fracture.
Does osteopenia inevitably become osteoporosis?
No. Bone density may change over time and fracture risk depends on additional factors. Discuss what follow-up fits your result.
Why are there scores for more than one site?
Hip and spine measurements can differ. The clinician checks each site’s validity and which score is relevant to the decision.
Does a normal score mean I cannot fracture a bone?
Fractures can occur at any bone density. Previous injuries, falls and other health factors still matter.
Does everyone need another scan in a year?
Repeat timing is individual. It depends on factors such as treatment, fracture risk, expected change and whether a new result would change care.
Can two reports from different scanners be compared directly?
Ask the imaging service. Differences in devices, calibration and technique can prevent a reliable comparison of small changes.
Important medical note
This article is for general educational information only. It is not medical advice, diagnosis, or a treatment plan. Medicines should be used only under the guidance of a qualified healthcare professional. Product availability, export documentation, and quotation support do not imply that a medicine is appropriate for any individual patient.